Table of Contents
Advertisement
Installer manual Siata V132 - SFE - Programming
where :
•
d.xxx : incoming water hardness, in French degrees [°f] or [ppm];
•
do.xx: desired outgoing water hardness, in French degrees [°f];
•
C:xx: exchange capacity of the regenerating resin used, expressed in [°f x m
CaCO
;
3
•
L.xxx: volume of resin, expressed in liters [L].
The result must be typed, rounded down to the closest integer.
A
Note
The desired outgoing water hardness value must be compatible with the provisions of the
regulations in force where the controller is used.
Duration of the first regeneration cycle stop
Set the duration of the first regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A
Use
and
to edit this parameter.
B
Press
to validate and switch to the next parameters.
Duration of the second regeneration cycle stop
Set the duration of the second regeneration cycle stop (minutes). If
the parameter is set to off, the stop will be skipped and the system
will go directly to the next stop.
A
Use
and
to edit this parameter.
B
Press
to validate and switch to the next parameters.
Duration of the third regeneration cycle stop
Set the duration of the third regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A
Use
and
to edit this parameter.
B
Press
to validate and switch to the next parameters.
Duration of the fourth regeneration cycle stop
Set the duration of the fourth regeneration cycle stop (minutes). If the
parameter is set to off, the stop will be skipped and the system will
go directly to the next stop.
A
Use
and
to edit this parameter.
B
Press
to validate and switch to the next parameters.
48 / 88
3
/L] or in [g/L
Ref. MKT-IM-003 / B - 19.04.2017
] of
resin
Hide quick links:
Advertisement
Table of Contents
