Movement And Stability Of The Unit; Maintenance And Repair; Modifications To The Product; Operating Instructions Cerec Omnicam Ac / Omnicam Ac - Dentsply Sirona CEREC Omnicam AC Operating Instructions Manual

Dentsply Sirona

Operating Instructions CEREC Omnicam AC / Omnicam AC

66 54 656 D3696
D3696.201.02.03.02 05.2019
2.2.4

Movement and stability of the unit

NOTE
The unit can overturn or slip away
For reasons of tilt stability, the unit must be pulled by its front or rear
handle when being moved. If you push the unit, obstacles on the floor
could block its wheels, thus causing it to overturn.
For transporting the unit (for example to another room), the monitor
must be in a rotated position in order to prevent damage through
impacts. The monitor may be in the upper or swiveled out position.
Make sure that the unit is transported in a stable manner.
All wheels of the unit have brakes which can be locked to ensure
secure positioning. If the unit is steeply inclined or standing on a
slippery surface and lateral forces are acting on it, it may slide even
though the wheel brakes are locked. Horizontal forces in the upper
part of the unit (e.g. on the monitor) can cause the unit to tip over
when the wheels are stationary.
➢ Always make sure that the unit's footprint is a flat, nonskid
surface.
NOTE
Tripping hazard posed by cable connection to USB ports on the
monitor
Tripping hazards that compromise tipping stability may arise due to
the connection of USB cables to the USB ports on the monitor.
➢ Do not connect USB cables to the USB ports on the monitor.
➢ Always connect USB cables to the sockets on the rear of the PC.
2.2.5

Maintenance and repair

As manufacturers of dental instruments and laboratory equipment, we
can assume responsibility for the safety properties of the unit only if the
following points are observed:
● The maintenance and repair of this unit may be performed only by
Dentsply Sirona or by agencies authorized by Dentsply Sirona.
● Components which have failed and influence the safety of the unit
must be replaced with original (OEM) spare parts.
● Only original cables may be used, so that EMC requirements are
met.
Please request a certificate whenever you have such work performed. It
should include:
● The type and scope of work.
● Any changes made in the rated parameters or working range.
● Date, name of company and signature.
2.2.6

Modifications to the product

Modifications to this product which might affect the safety of the system
owner, patients or other persons are prohibited by law!
2 Safety instructions
2.2 Basic safety information
19