ProMinent Makro/ 5 Operating Instructions Manual page 9

Qualification of personnel
The pump may only be started up after it has been correctly
n
installed and commissioned in accordance with the technical
data and specifications contained in the operating instructions.
The general limitations with regard to viscosity limits, chemical
n
resistance and density must be observed - see also ProMinent
resistance list (In the product catalogue or at
www.prominent.com )!
Any other uses or modifications are prohibited.
n
Pumps without the relevant nameplate (and the respective EC
n
Declaration of Conformity) for pumps for potentially explosive
atmospheres must never be operated in potentially explosive
atmospheres.
The pump is not intended for the metering of gaseous media or
n
solids.
The pump is not intended for unprotected outside use.
n
The pump is only approved to meter flammable liquids, if the
n
operator takes appropriate safety measures.
The pump should only be operated by trained and authorised
n
personnel, see also
You are obliged to observe the information contained in the
n
operating instructions at the different phases of the device's
service life.
In hazardous locations only the following combinations of identity
code variants is permitted:
Combi‐ Identity code specification
nations
1 Electric power supply
Motor version
Stroke length adjustment
2 Electric power supply
Motor version
Stroke length adjustment
Activity
Storage, transport, unpacking
Assembly, installation of
hydraulic system
Installation, electrical
Operation
Maintenance, repair
Ä 'Qualification of personnel' on page 9 .
Qualification level
Instructed person
Technical personnel, service
Electrical technician
Instructed person
Technical personnel, service
Safety chapter
values
L, P
1,2, V(2)
0, G, H
0, 5.6
A
0, G, H
9