ProMinent Makro/ 5 Operating Instructions Manual page 23

Liquid end alignment
Fastening
m
m
P_MOZ_0015_SW
Fig. 13
Instruction
Capacity too low
If the valves of the liquid end do not stand upright, they
cannot close correctly.
–
Capacity too low
Vibrations can disturb the valves of the liquid end.
–
Take the dimensions (m) for the fastening holes from the appro‐
priate dimensional drawings or data sheets.
DN
Fasten the pump base to the supporting floor using suitable
screws.
Screw the pump to a support surface with 4 sufficiently
strong screws through the 4 holes in the frame.
Nothing more need be fitted to the pump itself: the pump is filled
with gear oil and completely assembled on a frame.
The discharge valve must be upright.
Secure the metering pump so that no vibrations
can occur.
Assembly
23