Decommissioning And Disposal; Decommissioning - ProMinent Makro/ 5 Operating Instructions Manual

Decommissioning and disposal

14 Decommissioning and disposal
14.1

Decommissioning

48
WARNING!
Warning about personal and material damage
EX pumps only: When operating in EX areas, certain
subjects must be observed.
– The chapter "Important supplements for metering
pumps in EX zones" of the "General Operating
Instructions on ProMinent
Pumps and Hydraulic Accessories" must be
observed in all cases.
WARNING!
Danger of an electric shock
When working on the motor or electrical auxiliary
equipment, there is a danger of an electric shock.
– Before working on the motor, take note of the
safety instructions in its operating instructions!
– Should external fans, servomotors or other auxil‐
iary equipment be installed, these should also be
disconnected and checked that they are voltage
free.
WARNING!
Danger from chemical residues
There is normally chemical residue in the liquid end
and on the housing after operation. This chemical res‐
idue could be hazardous to people.
– It is mandatory that the safety note relating to the
"Storage, Transport and Unpacking" chapter is
read before shipping or transporting the unit.
– Thoroughly clean the liquid end and the housing of
chemicals and dirt. Adhere to the safety data sheet
for the feed chemical.
WARNING!
Warning of hazardous or unknown feed chemical
Should a hazardous or unknown feed chemical be
used, it may escape from the hydraulic components
when working on the pump.
– Take appropriate protective measures before
working on the pump (protective eyewear, protec‐
tive gloves, ...). Read the safety data sheet on the
feed chemical.
– Drain and flush the liquid end before working on
the pump.
Motor-Driven Metering
®