Assembly / Adjustment; Receiver And Servo Connection; Receiver Antenna Installation - FUTABA 3pv-2.4g Instruction Manual

Receiver and Servo Connection

As you connect the receiver, servos and other components, do so in accordance with the
"Assembly Precautions".
Installation When An Electronic Speed Control Is Used
e.g. R314SB
To Battery

Receiver Antenna Installation

Install the R203GF/R304SB/R314SB receiver on the car as follows:
Note: The operating range may become shorter, depending on where the
receiver and the antenna are mounted.
WARNING
Install the antenna in the higher place as shown in the figure.
Keep the antenna as far away from the motor, ESC and other
noise sources as possible.
Put the antenna in the antenna tube to protect it.
Do not cut the antenna.
Do not bend the coaxial cable. Doing so causes damage.
12

Assembly / Adjustment

Installation For Gas Powered Models
e.g. R314SB
CH4
CH1
Receiver
B/C
Switch
CH4 servo
CH3
CH3 servo
Throttle servo
CH2
Steering servo
Antenna
tube
Antenna
Coaxial
cable
Receiver