Checking the oil level in the
vibration bearing
Fig. 113
Drive the machine until the oil level control plug
•
1 (Fig. 113) is vertically below the hub.
Clean the plug and screw it out.
•
The oil level must reach the lower edge of the bore
If necessary top up oil through the filler and drain
•
bore (2).
For quality of oil refer to the table of fuels and
lubricants�
4-2012
MAINTENANCE
Checking the oil level in the
drum drive gear
Only dh and Pdh machines
Fig. 114
Move the machine until one plug 1 (Fig. 114) is in
•
horizontal and one plug (2) in top position.
Clean and unscrew plug (1).
•
The oil level must reach the bottom edge of the bore.
If necessary clean and unscrew plug (2) and fill in
•
oil.
For quality of oil refer to the table of fuels and
lubricants�
Section 5
5-23