Checking The Coolant Level; Checking The Hydraulic Oil Level - Fayat Group BOMAG BW177D-50 Operating Instructions, Maintenance Instructions

Section 5
MAINTENANCE

Checking the coolant level

danger of scalding!
Never remove the cap from the
compensation tank when the engine
is hot�
Fig. 98
Check the coolant level (Fig. 98).
•
if, during the daily inspection the coolant
level is found to have dropped, check all
lines, hoses and engine for leaks�
do not use any radiator sealing agents
to seal leakages�
do not fill any cold liquids into a hot
engine�
To top up unscrew the filler cap and fill in coolant
•
up to the MAX-mark.
For quality of coolant refer to the chapter, fuels and
lubricants�
5-16

Checking the hydraulic oil level

in hydraulic systems filled with hv68
(TdhType) always use the same oil to
top up�
Fig. 99
Check the hydraulic oil level in the inspection
•
glass (Fig. 99).
Normal level
approx. 3 cm below the top edge of the inspection
glass.
minimum level
Middle of inspection glass.
if, during the daily inspection of the oil
level the hydraulic oil level is found to
have dropped, check all lines, hoses and
components for leaks�
If necessary fill in hydraulic oil through the filler
•
neck.
For quality and quantity of oil refer to the table of
fuels and lubricants�
4-2012