Vxlan Udp-Port - HP 6127XLG Series Command Reference Manual

Use undo vxlan tunnel mac-learning disable to restore the default.
Syntax
vxlan tunnel mac-learning disable
undo vxlan tunnel mac-learning disable
Default
Remote-MAC address learning is enabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
When network attacks occur, use this command to prevent the device from learning incorrect remote
MAC addresses in the data plane.
Examples
# Disable remote-MAC address learning.
<Sysname> system-view
[Sysname] vxlan tunnel mac-learning disable

vxlan udp-port

Use vxlan udp-port to configure the destination UDP port number of VXLAN packets.
Use undo vxlan udp-port to restore the default.
Syntax
vxlan udp-port port-number
undo vxlan udp-port
Default
The destination UDP port number is 4789 for VXLAN packets.
Views
System view
Predefined user roles
network-admin
Parameters
port-number: Specifies a UDP port number in the range of 1 to 65535. To avoid conflict with well-known
ports, HP recommends that you specify a port number in the range of 1024 to 65535.
Usage guidelines
You must configure the same destination UDP port number on all VTEPs in a VXLAN.
Examples
# Set the destination UDP port number to 6666 for VXLAN packets.
<Sysname> system-view
28