Danfoss VLT Center Winder MCO 352 Operating Instructions Manual page 26

4 How to Install
19-94 Program Loop Scan Time
Option:
19-95 Winder Speed Counts
Option:
19-96 Line Speed Counts
Option:
4
19-97 Diameter Size
Option:
19-98 Tapered Tension Set-Point
Option:
19-99 Tension Feedback
Option:
26
Function:
Read only parameter used to display the time[ms] per program loop scan.
Function:
Read only parameter used to display the winder speed counts. 100000 counts = 100 % winder
speed.
Function:
Read only parameter used to display the line speed counts. 100000 counts = 100 % line speed.
Function:
Read only parameter used to display the diameter of the roll. 100000 counts = 100 % diameter.
Function:
Read only parameter used to display the Tapered tension set point 1000 = 100.0% tension.
Function:
Read-only parameter used to display the actual tension feedback. A reading of 1000 = 100.0 % of
the 20 mA, or 10 V signal from the load cells or dancer.
®
MG.33.T1.02 - VLT is a registered Danfoss trademark
®
VLT Center Winder MCO 352