Table of Contents
Advertisement
Digital Projection E-Vision Laser WQ120 Series
Setup menu continued from previous page
ColorMax
permits seven point color
ColorMax
matching of red, green, blue, yellow,
cyan, magenta and white.
You can enter your own gamut values
here, or edit values you have imported
using the Projector Controller
software.
Defining your own colorspace with
individual x and y coordinates for each
color enables you to match not only
the whites but each individual color as
well.
Highlight the submenu you wish to
open and press
to confirm
ENTER/OK
your choice.
Measured Data / Target Data
1.
Use the
and
UP
DOWN
arrow buttons to highlight a color,
then use the
and
LEFT
RIGHT
arrow buttons to navigate to the
or
coordinate.
x
y
2.
Use the
and
UP
DOWN
arrow buttons to increase and
decrease the value, respectively.
3.
Exit edit mode:
•
press
, if you want
ENTER/OK
to save the edited values.
•
press
, if you do not wish
EXIT
to save the edited values
4.
If necessary, highlight another color and repeat the procedure.
Operating Guide
Measured Data
Red
x: 0.658
y: 0.339
Green
x:
0.315
y: 0.662
Blue
x: 0.146
y: 0.043
White
x: 0.276
y: 0.283
Reset
USING THE PROJECTOR
ColorMax
Measured Data
Target Data – User 1
Target Data – User 2
Target Data – User 1
Red
x: 0.640
Green
x: 0.300
Blue
x: 0.150
Yellow
x: 0.419
Cyan
x: 0.225
Magenta
x: 0.321
White
x: 0.285
Notes
u
u
The Projector Controller software
u
is available for download from the
Digital Projection website, free of
charge.
This tool is best used in conjunction
with a specialized light meter (a
photo spectrometer) to measure
color parameters within a particular
installation. However, the preloaded
generic factory default data set
is designed to give more than
satisfactory results.
y: 0.390
y: 0.600
y: 0.060
y: 0.505
y: 0.329
y: 0.154
y: 0.302
Rev A May 2018
page 49
Advertisement
Table of Contents
