Delta Amplon Series User Manual page 50

For setup procedures, please refer to the following:
In the Main Menu, select the item you want to configure, press the ENTER
1
button
Press the button
2
navigate the setting items.
Press the button
3
change, and the parameter will flash.
Press the button
4
increase or decrease the parameter value. If either of the buttons is pressed
for over 2 seconds, the LCD will automatically switch between the selectable
values every 0.2 second until either of the buttons is released or the number
reaches its highest or lowest value.
Press the button
5
to go back to the previous status.
After that, press the button
6
second to move to the previous or the next setting item.
In setup mode, press the
7
mode.
In setup mode, if you don't press any button for more than 5 minutes, the LCD
8
will exit from the setup mode and go back to the original display automatically.
Please refer to the Menu Tree below for all setting options.
Amplon RT Series
for 0.1 second and the UPS will enter into the setup mode.
for 0.1 second or press the button
for 0.1 second to choose the parameter that you want to
for 0.1 second or press the button
to confirm your parameter setup or press the button
for 0.1 second or press the button
button and the LCD will exit from the setup
ESC
4 6
for 0.1 second to
for 0.1 second to
ESC
for 0.1