Mercedes-Benz Sprinter Operating Instructions Manual page 232

230
Wheels and tyres
You can, however, also update the reference val‐
ues by restarting the tyre pressure monitoring
system manually ( page 230).
→
System limitations
The system may be impaired or may not function
in the following situations:
if the tyre pressure is set incorrectly
R
if there is a sudden pressure loss caused by a
R
foreign object penetrating the tyre, for exam‐
ple
if there is a malfunction caused by another
R
radio signal source
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Checking the tyre pressure with the tyre
pressure monitoring system
Requirements:
The ignition is switched on.
R
On-board computer:
Service Tyres
, .
One of the following displays appears:
the current tyre pressure and tyre tempera‐
R
ture of the individual wheels
Instrument display with colour display
the current tyre pressure for each wheel
R
Instrument display with black and white display
page 218)
→
Tyre pressures will be displayed after a few
R
minutes of driving: the teach-in process of the
system is not yet complete. The tyre pres‐
sures are already being monitored.
Compare the tyre pressure with the recom‐
#
mended tyre pressure for the current operat‐
ing condition . Observe the notes on tyre tem‐
perature ( page 218).
→
%
The values displayed in the multifunction dis‐
play may deviate from those of the tyre pres‐
sure gauge as they refer to sea level. At high
altitudes, the tyre pressure values indicated
by a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tyre pressures.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Restarting the tyre pressure monitor
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating condition on
each of the four wheels (
Restart the tyre pressure monitoring system in
the following situations:
The tyre pressure has changed.
R
The wheels or tyres have been changed or
R
newly fitted.
On-board computer:
Service Tyres
, .
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The Use current pressures as new reference
values message is shown in the multifunction
display.
Press the left-hand side of Touch Control on
#
the steering wheel to initiate a restart.
The OK message is shown in the multifunc‐
tion display.
Current warning messages are deleted and
the h yellow warning lamp goes out.
After you have driven for a few minutes, the
system checks whether the current tyre pres‐
sures are within the specified range. The cur‐
rent tyre pressures are then accepted as ref‐
erence values and monitored.
page 218)
→
page 218).
→