Mercedes-Benz Sprinter Operating Instructions Manual page 57

To interrupt convenience opening: release
#
the % button.
Closing side windows from the outside (con‐
venience closing)
& WARNING Risk of entrapment caused by
inadvertent convenience closing
When the convenience closing feature is
operating, parts of the body could become
trapped in the closing area of the side win‐
dows.
Observe the complete closing proce‐
#
dure when using convenience closing.
When closing, make sure that no body
#
parts are in the closing area.
Problems with the side windows
Problem
A side window cannot be
closed and the cause is
not obvious.
The side windows cannot
be opened or closed
using the convenience
opening feature.
Possible causes/consequences and
Check to see if there are any objects in the window guide.
#
& WARNING Risk of becoming trapped or fatally injured if revers‐
ing protection is not activated
If you close a side window again immediately after it has been
blocked or reset, the side window closes with increased or maximum
force. The reversing feature is then not active.
Parts of the body could become trapped in the closing area in the
process.
Make sure that no parts of the body are in the closing area.
#
To stop the closing process, release the button or press the
#
button again to reopen the side window.
If a side window is obstructed during closing and reopens again slightly:
Immediately after the window gets stuck, pull the corresponding but‐
#
ton again until the side window has closed, and hold the button for
an additional second.
The side window is closed with increased force.
If a side window is obstructed again and reopens again slightly:
Repeat the previous step.
#
The side window is closed without the automatic reversing function.
the key battery is weak or discharged
Check the battery with the battery indicator lamp and replace if nec‐
#
essary( page 41).
→
Press and hold the & button on the key.
#
The following functions are performed:
the vehicle is locked
R
the side windows are closed
R
To interrupt convenience closing: release
#
the & button.
Adjusting the side windows
The side windows must be readjusted after a mal‐
function or a voltage supply interruption.
Switch on the ignition (
#
Push both buttons on the power window and
#
hold for approximately one second after the
side window has closed.
Solutions
M
Opening and closing
page 109).
→
55