Reassembly Of The Driver; Figure 12 Check Of Axes And Rolls - M&C CSS Series Instruction Manual

•
Dismount roller axes and change contact pulleys. Take care that axes are not worn out by the
springs and have damaged the dent at the axes front end. In case of abrasion the axes have to
be changed (see Figure 12).
worn out
Figure 12 Check of axes and rolls
N O T E !
N O T E !
•
Make sure that contact pulleys move easily on the axis. After remounting the axis with contact
pulley into the driver the spring has to be mounted as shown as in Figure 12. Please pay attention
to the alignment of the dent.

15.3.3 REASSEMBLY OF THE DRIVER

Reassemble the driver in reverse order:
•
Insert the roll carrier back into the pump head
•
Push the pump head with the roll carrier onto the motor shaft
•
Tighten the nuts of the pump head fastening (SW 5.5)
28
new
The springs may come in different colorings. This is not a quality
impairment. Make sure to use the right spring strength. This can be
identified by the spring wire diameter. The 'standard version for
Novoprene pump tubing' (Part No. 90P1010) has a diameter of 1.1 mm and
the 'reinforced version for FPM-, Acidflex- or Masterflex-tubing' (Part No.
90P1015) has a diameter of 1.2 mm.
Two different types of springs are mounted inside the driver (right and left
springs) for the first delivery. When spare springs are ordered, for
simplified storage, only one type will be delivered (right spring) which can
be used for all four springs and will replace without any problems the
initial springs. The replacement springs guarantee full functionality when
all four springs are replaced.
CSS-V | 1.01.02
The dent prevents
rotation of the axis


.
www.mc-techgroup.com