Changing Contact Pulleys And Springs; Figure 10 Different Pump Tube Sizes; Figure 11 Disassembly Of Pump Head And Driver - M&C CSS Series Instruction Manual

Figure 10 Different pump tube sizes

15.3.2 CHANGING CONTACT PULLEYS AND SPRINGS

N O T E !
Follow these instructions to change the contact pulley and springs:
•
Disconnect the peristaltic pump from power supply
•
Unscrew nuts of the pump head (wrench size 5.5)
1 Pump head nuts
4 Groove

Figure 11 Disassembly of pump head and driver

•
Remove the pump head
•
Now the driver can be removed from the pump head and is ready for maintenance
•
The removal of the springs 4 pcs.)
any tools. For this take spring out of the groove
www.mc-techgroup.com
While mounting, make sure that the center of rotation and the driver
are aligned.
Use genuine spare parts only!
2 Pump head
5 Driver (roll carrier)

from the motor shaft


3 Springs
6 Collar of the shaft bore
away from the driver is easily possible without the aid of

near to the shaft bore
CSS-V | 1.01.02 27