Changing The Pump Tubing; Figure 9 Changing The Pump Tubing - M&C CSS Series Instruction Manual

15.3.1 CHANGING THE PUMP TUBING

1 Conveying belt
4 contact pulley
Figure 9 Changing the pump tubing
For changing the pump tubing please proceed as follows:
•
Unplug the pump from the mains voltage. The device needs to be voltage free.
•
•
Press conveying belt
•
Take away conveying belt
tube connectors;
•
Press the two contact pulleys
the contact springs have to be changed (see chapter 15.3.2);
•
Put the new tubing set
N O T E !
•
Put the conveying belt
•
Press conveying belt at the recessed grips and simultaneously turn the S-bolt
until it snaps;
•
Switch on pump.
26
2 S-bolt
5 springs

at the recessed grips and turn S-bolt

and remove the old tubing set

and check whether the spring pressure is still sufficient, if not,

with the tube connectors into the guides of the conveying belt
Only the usage of the original tubing set guarantees a proper functionality.
Never lubricate the tube.
Before mounting the pump check all parts for contaminations and clean if
necessary.

with the new tubing
CSS-V | 1.01.02
3 Tubing set


into the dovetail guide of the pump body;

clockwise up to limit stop;
from the guides by pulling on the

anticlockwise
www.mc-techgroup.com

;