Table of Contents
Advertisement
1.3
Symbols used in the safety instructions
Danger: These safety instructions point out an imminent danger for the life and health of persons!
Non-compliance with these warnings can result in danger to life, life-threatening injuries and
property damage.
Attention: These safety instructions point out possible dangers from electrical current!
Non-compliance with these warnings can result in injuries and property damage!
Note: These safety instructions point out important information which you must follow for the safe
operation of the FreeStand sit/stand desk.
Danger: These safety instructions point out a possible danger of crushing which exists in
exceptional cases.
Non-compliance with these warnings can result in danger to life, life-threatening injuries and
property damage.
Note: Note on the obligation to read the operating instructions!
Note: Pull the power cord before going to the next step!
1.4
Safety Instructions
These operating instructions contain safety instructions which inform you about potential hazards and thus
facilitate the safe operation of the FreeStand sit/stand desk. Please be sure you comply with these safety
instructions!
This section provides you with general safety information that does not refer to any specific work step. You can
find the job-specific safety instructions in the respective section of the operating instructions. You will find
additional safety instructions on the individual parts of the FreeStand sit/stand desk.
1.4.1 General safety instructions
Note: Before assembly/commissioning, of the FreeStand sit/stand desk, you must read and comply
with the operating instructions!
Attention: Never open the SMART motor controller under any circumstances! There is a danger of
electric shock.
Attention: The FreeStand sit/stand desk is not designed for continuous duty. The desktop height
must not be adjusted without interruption for a time period longer than the operating time stated on
the rating plate.
Attention: The SMART motor controller must only be operated with the mains voltage specified on
the rating plate!
5
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
