Click Codes Of The Controller - OMT FREE.STAND 9029 Installation And Operating Instructions Manual

Display Cause
E71 Sensor – configuration
changed
E81 Internal error
Note: The PowerFail detection of the motor controller detects power failures and saves all
relevant data before the voltage drops below a critical level.
In a few exceptional cases, this saving process is not possible, and during the next controller start-
up, E81 is displayed and the controller clicks three times.
To repair this error, a manual reset is required (see Section 5).
Note: If there is a power failure during the height adjustment or if the mains cable is pulled, a
manual reset might be necessary.
If the error cannot be repaired as described above, pull the mains plug, wait for several minutes and try to
reinitialise the desk!
If the error continues to occur, unplug the desk from the mains and contact customer service.
This error list is suitable for firmware 1.9.14 and higher!
9

Click codes of the controller

As soon as the motor controller is supplied with power, the controller uses the integrated relay to acoustically
inform the user about the system status and the reason for the most recent shut-down.
Number When
of clicks
2x When
mains on
1x
3x – 6x
Repair
An (optionally) mounted sensor was removed or the connection has
been lost.
Comply with the separate instructions for the sensor!
Reinitialise desk (RESET)
Pull the power supply cable and reconnect after several seconds.
If the error occurs regularly, unplug the power supply cable and
contact customer service.
Status information
Normal operation: The system is functioning without problems
Emergency
The system is running in emergency mode; the drives cannot be used. Check the
LED if applicable and/or the error code on the display of the hand-switch.
Last shut-down incomplete / forced reset:
Check the LED if applicable and/or the error code on the display of the hand-
switch.
mode:
23