Symbols Used In The Safety Instructions; Safety Instructions; General Safety Instructions - OMT FREE.STAND 9051 Installation And Operating Instructions Manual

1.3 Symbols used in the safety instructions

Danger: These safety instructions point out an imminent danger for the life and health of persons!
Non-compliance with these warnings can result in danger to life, life-threatening injuries and
property damage.
Attention: These safety instructions point out possible dangers from electrical current!
Non-compliance with these warnings can result in injuries and property damage!
Note: These safety instructions point out important information which you must follow for the safe
operation of the FREE.STAND sit/stand desk.
Danger: These safety instructions point out a possible danger of crushing which exists in
exceptional cases.
Non-compliance with these warnings can result in danger to life, life-threatening injuries and
property damage.
Note: Warning on the obligation to read the operating instructions!
Note: Pull the power cord before going to the next step!

1.4 Safety Instructions

These operating instructions contain safety instructions which inform you about potential hazards and thus
facilitate the safe operation of the FREE.STAND sit/stand desk. Please be sure you comply with these safety
instructions!
This section provides you with general safety information that does not refer to any specific work step. You can
find the job-specific safety instructions in the respective section of the operating instructions. You will find
additional safety instructions on the individual parts of the FREE.STAND sit/stand desk.

1.4.1 General safety instructions

Note: Before assembly/commissioning, of the FREE.STAND sit/stand desk, you must read and
comply with the operating instructions!
Attention: Never open the STAND.CONTROL motor controller under any circumstances! There is
a danger of electric shock.
Attention: The FREE.STAND sit/stand desk is not designed for continuous duty. The desktop
height must not be adjusted without interruption for a time period longer than the operating time
stated on the rating plate.
9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
5