Procedure During Commissioning; Connect The Drives - OMT FREE.STAND 9029 Installation And Operating Instructions Manual

4.5.2 Procedure during commissioning

Attention: Plug in the power supply cable/mains cable only after all other electrical connections
have been made! (All motors, the hand-switch and possibly additional accessories are connected
to the controller.)
To commission the FreeStand sit/stand desk, proceed as follows:

4.5.3 Connect the drives

Make sure that the connection cables of the drives reach from both sides up to the corresponding
controller connection. For extremely long desks, it might be necessary to assemble the controller off-
centre. For especially large desks, if necessary use an extension cable for the connection cable of the
drives.
Connect the drives of the side panels and the controller using the motor cable. The plug connectors on
the 8-pin motor sockets must firmly latch! For controllers with more connections for drives than the
number of drives available, you must start by connecting the (M1) connection. If, for example, only a
drive is connected to the motor controller, the M2 connection remains open.
Note: When inserting the motor cable, the sequence of M1, M2 must be maintained!
13