Assembly Of The Worktop Support And Cross-Beams; Assembly Of The Desktop; Assembly Of The Controller And Hand-Switch - OMT FREE.STAND 9029 Installation And Operating Instructions Manual

4.2

Assembly of the worktop support and cross-beams

Now assemble the two cross-beams and the support elements on both side elements. To do that, use
solely the M8 bolts as per the base drawing! The max. tightening torque for these bolts is 20 Nm.
From the inside, screw
two bolts into the cross-
head threads.
Note: Experience has shown that it is better to first loosely preassemble the bolts for the cross-
beams and then tighten them in the described sequence.
4.3

Assembly of the desktop

Now fasten the desktop to the desk base in accordance with the base drawing. To accomplish that, 6.5
mm holes are provided on the desk frame; they are suitable for ø5.5 to ø6.0 mm bolts. Use all provided
*1)
bolting points.
4.4

Assembly of the controller and hand-switch

Now attach the controller and the hand-switch to the desktop. ø5.4 mm are provided on the controller
and ø4.5 mm holes are provide on the hand-switch for that purpose. For the controller, use bolts with a
4x M8 bolt
From the outside, screw two
bolts into the bracket threads
of the support elements.
If a CPU holder
should
integrated into the
system, then please
connect both
interior bolts to the
cross-heads via the
column's head
plate.
be
11