Table of Contents
Advertisement
4
Assembly
Use only screws that correspond to the enclosed base drawing for the assembly of your desk base.
Attention: Incorrect screws can cause damage to the desk.
Danger: The power cable of the motor controller must be disconnected during assembly of the
desk base!
Attention: Before assembly and commissioning of the FreeStand sit/stand desk, make sure the
product is acclimatised for the temperature and relative humidity values stated in the technical
data!
4.1
Installing the actuators
For side elements with permanently welded actuators, proceed with Point 4.2.
Side elements with bolted actuators must be installed first on the assembly columns. Use the bolts in the
desk base drawing.
The max. tightening torque is 10 Nm!
The max. depth of engagement of the M10 bolts is 9 mm!
If you have asymmetric actuators (C-shape) you will need a left-hand and a right-hand side element.
M10 bolts as per base drawing
Run
Installation
10
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
