Table of Contents
Advertisement
The display shows the current desk height in centimetres or inches and on top of that it shows the operating
condition of the controller along with any detected problems with the error code "Exx". You can find a list of all
possible error codes in the troubleshooting section.
If you stop pressing the hand-switch after a while, the display turns off if no important operating condition is
being displayed. As soon as you press a button, the display switches back on.
The "Up" and "Down" buttons plus the "Move desk up" and "Move desk down" buttons move the desk as
described in 6.1.
Note:
unpowered state (pull the mains plug beforehand). Only then will the new type be correctly
detected by the motor controller.
How to save a position:
Move
the
desk
Press the "S" button ("S" appears in the display) and then one of the position buttons 1 to 2 or 4 (you can see,
e.g. "S 1" in the display). The controller confirms the storage procedure with a double-click sound and after
approx. 2 seconds the current desk height is shown in the display. This way you can save 2 or 4 different
positions.
How to retrieve a saved position:
Keep the desired memory setting pressed (1, 2, 3 or 4). The desk independently moves from the current
position to the saved position. The button has to be pressed until the position is reached; if you let go
beforehand, the desk stops moving.
Change the height display unit (S5 menu)
The height display of the hand-switch can be shown in either centimetres or inches. Use the S5 menu to convert
the unit. If the display was set to centimetres, after menu selection the height will be shown in inches; if inches
were previously displayed, you can revert to the centimetre display.
To change the unit proceed as below:
1. Simultaneously press the buttons "1", "2" and "UP" (approx. 3-5 sec.) until the display shows "S x". (x stands
for a number; if "S 5" is being displayed, continue with 3.)
2. Press the UP or DOWN button until the display shows "S 5".
3. Press the S-button. The display is now reset to the previous setting from centimetres to inches or from
inches to centimetres.
To exit the menu, wait about 10 seconds until the height display reappears.
Calibrate the height display
If the displayed height does not match the actual height,
you can correct the display as below:
1. Press the S-button and let it go again.
2. Press the DOWN button until the height display starts flashing. (approx. 5 sec.)
3. Measure the desk height and enter the measured value (depending on the setting, in centimetres or inches)
using the UP or DOWN button. Confirm the input by briefly pressing the S-button.
If the hand-switch type on the motor controller is replaced, this has to be done in an
to
the
desired
height
with
the
"Up"
or
"Down"
buttons.
17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
