Change The Front Bulbs - Seat Arona 2018 Owner's Manual

CAUTION
Remove the ignition key before working
●
on the electric system. Otherwise, a short
circuit could occur.
Switch off the lights or parking lights be-
●
fore you change a bulb.
For the sake of the environment
Please ask your specialist retailer how to
dispose of used bulbs in the proper manner.
Note
Depending on weather conditions (cold
●
or wet), the front lights, the fog lights, the
tail lights and the turn signals may be tem-
porarily misted. This has no influence on
the useful life of the lighting system. By
switching on the lights, the area through
which the beam of light is projected will
quickly be demisted. However, the edges
may continue to be misted.
Please check at regular intervals that all
●
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
Before changing a bulb, make sure you
●
have the correct new bulb.
Do not touch the glass part of the bulb
●
with your bare hands, use a cloth or paper
towel instead. The residue left by the fin-
gerprints would vaporise as a result of the
94
Emergencies
heat generated by the bulb, they will be
deposited on the reflector and will impair
its surface.
Depending on the level of equipment fit-
●
ted in the vehicle, LEDs may be used for
part or all of the interior and/or exterior
lighting. LEDs have an estimated life that
exceeds that of the vehicle. If an LED light
fails, go to an authorised workshop for its
replacement.

Change the front bulbs

Main beam headlight bulb
In the engine compartment: main
Fig. 101
beam lamp.
Raise the bonnet.
–
Turn the cover anti-clockwise and take it
– 1
›››
out Fig. 101.
Remove the bulb connector
–
outwards.
Remove the bulb by pulling it out and fit the
–
new one.
Fit the bulb connector .
– 2
Fit cover , turning it towards the right.
– 1
Check whether the new bulb is working.
–
by pulling it
2