Seat Arona 2018 Owner's Manual page 296

too much traffic or in a car park when there
are good weather and visibility conditions.
Cleaning the camera lens
Keep the camera lens clean and clear of
snow and ice:
Moisten the lens using a normal alcohol-
●
based glass cleaning product and clean the
lens with a dry cloth.
Remove snow using a small brush.
●
Use de-icing spray to remove any ice.
●
CAUTION
Never use abrasive cleaning products to
●
clean the camera lens.
Do not use hot or warm water to remove
●
ice or snow from the camera lens. Doing so
could damage the camera.
1)
WARNING: the RVC (Rear View Camera) func-
tion button will only be activated and available
when the reverse gear is engaged or the selector
lever is set to position R.
294
Driving
Parking and manoeuvring with the
rear assist
Display on the Infotainment system
Fig. 262
screen: guidance lines.
Switching the system on and off
The rear assist will switch on when the igni-
●
tion is on or the engine running, on engaging
reverse gear (manual gearbox) or on chang-
ing the selector lever to the R position (auto-
matic gearbox).
The system switches off 8 seconds after
●
disengaging reverse gear (manual gearbox)
or removing the selector lever from the R po-
sition (automatic gearbox). The system will
also disconnect immediately after the ignition
is switched off.
The camera will stop transmitting images
●
above the speed of 15 km/h (9 mph) with re-
verse engaged.
In combination with the Parking System Plus
›››
page 286, the camera image will cease to
be transmitted immediately when reverse
gear is disengaged or when the selector lever
is moved from the R position, and the optical
information provided by the Parking Aid sys-
tem will be displayed.
Also in combination with the system, the rear
assist image can also be concealed:
By pressing one of the Infotainment system
●
buttons on the display.
OR: By pressing the miniature vehicle that
●
appears on the left of the screen (which
switches to the full-screen mode of the Park-
ing System Plus's optical system).
If you wish to display the rear assist image
again:
Disengage reverse, or change the selector
●
lever's position, engage reverse again or
move the selector lever to position R.
OR: Press the RVC function button
●
1)