Seat Arona 2018 Owner's Manual page 236

In certain circumstances (i.e. traffic hold-ups,
short stops, etc.) and to improve comfort, the
vehicle can start up in the D2 gear ratio
Sport mode (S) must be selected for a sporty
driving style. This setting makes use of the en-
gine's maximum power output. When accel-
erating the gear shifts will be noticeable.
Press the brake pedal to move the selector
lever from N to D/S when the vehicle is sta-
tionary or at speeds below 3 km/h (2 mph)
›››
.
Under certain circumstances (e.g. when driv-
ing in mountains) it can be advantageous to
switch temporarily to tiptronic mode
›››
page 236, in order to manually select
gear ratios to suit the driving conditions.
WARNING
Take care not to accidentally press the
●
accelerator pedal when the vehicle is stop-
ped. The vehicle could otherwise start
moving immediately (in some cases even if
the parking brake is engaged) resulting in
the risk of an accident.
Never move the selector lever to R or P
●
when driving. Failure to follow this instruc-
tion could result in an accident.
With selector lever in any position (ex-
●
cept P) the vehicle must always be held
with the foot brake when the engine is run-
1) Valid for the 1.6 MPI 81 kW automatic engine.
234
Driving
ning. This is because an automatic gearbox
still transmits power even at idling speed,
1) .
and the vehicle tends to "creep". The ac-
celerator pedal must on no account be
pressed inadvertently when a gear is en-
gaged with the vehicle stationary. The ve-
hicle could otherwise start moving immedi-
ately (in some cases even if the parking
brake is engaged) resulting in the risk of an
accident.
While you are selecting a gear and the
●
vehicle is stopped with the engine running,
do not accelerate. Failure to follow this in-
struction could result in an accident.
As a driver you should never leave your
●
vehicle if the engine is running and a gear is
engaged. If you have to leave your vehicle
while the engine is running, you must apply
the handbrake and engage the parking
lock (P).
To avoid accidents, apply the handbrake
●
and put the selector lever in position P be-
fore opening the bonnet and working on the
vehicle with the engine running. Please al-
ways observe the important safety warn-
›››
ings page 315, Working in the engine
compartment.
Note
If the selector lever is moved accidental-
●
ly to N when driving, release the accelera-
tor and let the engine speed drop to idling
before selecting gear range D or S again.
Should the power supply to the selector
●
lever be interrupted in position P, the selec-
tor lever will be locked. If this should hap-
pen the manual release can be used
›››

page 40.
Selector lever lock
Selector lever lock.
Fig. 220
The selector lever lock prevents gears from
being engaged inadvertently, so that the ve-
hicle is not set in motion unintentionally.
The selector lever lock is released as follows:
Switch the ignition on.
–