Seat Arona 2018 Owner's Manual page 56

Removing
Attach the wire hook (vehicle tools
●
›››
Fig. 69 ) to one of the chambers of the
6
central wheel trim.
Insert the box spanner through the hook,
●
supporting it on the tyre and remove the
wheel trim.
Fitting
Fit the central wheel trim onto the rim. The
●
bottom of the "S" of the SEAT badge should
align with the inflation valve
Press the central trim firmly until it locks in
●
with an audible click.
Note
There is also a valve mark on the back of
the central wheel trim that indicates the
correct alignment.
54
Wheel bolt caps*
›››
Fig. 70 .
1
Wheel: wheel bolts with caps.
Fig. 71
Removal
Fit the plastic clip (vehicle tools) over the
●
cap until it clicks into place
Remove the cap with the plastic clip.
●
The essentials
›››
Fig. 71.
Wheel bolts
Tyre change: slacken the wheel bolts.
Fig. 72
Tyre change: tyre valve
Fig. 73
1
rect position for the anti-theft wheel locking
bolt or .
2 3
Use only the wheel wrench belonging to the
car to loosen the wheel bolts.
Loosen the wheel bolts only about one turn
before raising the vehicle with the jack.
and the cor-