Driving; Start And Driving; Starting And Stopping The Engine - Seat Arona 2018 Owner's Manual

Driving

Start and driving

Starting and stopping the
engine
Ignition key positions
Ignition key positions.
Fig. 215
Read the additional information carefully
›››

page 31
Ignition switched off, steering lock
›››
In this position Fig. 215 the ignition and
1
the engine are off and the steering may be
locked.
For the Steering lock to operate without the
ignition key, turn the steering wheel until it
Start and driving
locks with an audible sound. You should al-
ways lock the steering wheel when you leave
your vehicle. This will help prevent vehicle
›››
theft .
Switching the ignition or the glow plug
system on
Turn the ignition key to this position and re-
lease it . If the key cannot be turned or it is
2
difficult to turn from position
1
move the steering wheel from one side to the
other; this will release it.
Starting
The engine is started when the key is in this
position . Electrical devices with high pow-
3
er consumption are switched off temporarily
at the same time.
Each time that the vehicle is restarted, the ig-
nition key must be turned to position
repetitive start prevention lock of the igni-
tion prevents possible damage to the starter
motor if the engine is already running.
WARNING
The ignition key must NOT be removed
●
from the lock until the vehicle comes to a
standstill. Otherwise, the steering could be
immediately blocked- Risk of accident!
Always remove the key from the ignition
●
when leaving the vehicle, even if only for a
short period. This is especially important if
children or disabled people are left alone
in the vehicle. They could accidentally
start the engine or work electrical equip-
ment such as the electric windows, result-
ing in an accident.
Unsupervised use of the key could start
●
the engine or any electrical system, such
as the electric windows. This could result in
serious injury.
to position ,
2
CAUTION
The starter motor will only work when the
engine is stopped (ignition key position
Starting petrol engines
The engine can only be started using a genu-
ine SEAT key with its correct code.
. The
1
Move the gearbox lever to the neutral posi-
–
tion and depress the clutch pedal thor-
oughly and hold it in this position for the
starter to turn the engine on.
Turn the ignition key to the starting position
–
›››
Fig. 215
Let go of the ignition key as soon as the en-
–
gine starts; the starter motor must not run
on with the engine.
After starting a very hot engine, you may
need to slightly press down the accelerator.
).
3
.
3
»
217