Seat Arona 2018 Owner's Manual page 88

Hide thumbs Also See for Arona 2018:
Table of Contents

Advertisement

Contents of the tyre mobility sys-
tem*
Standard display: contents of the anti-
Fig. 96
puncture kit.
The anti-puncture kit is located underneath
the floor covering in the luggage compart-
ment. It includes the following components
›››
Fig.
96:
Valve insert remover
1
A sticker to be adhered to the instrument
2
cluster, within the driver's visual field, to
remind that the maximum advisable
speed "max. 80 km/h" or "max. 50 mph"
Filler tube with cap
3
Air compressor
4
ON/OFF switch
5
86
Emergencies
Air bleed screw (it can also be integrated
6
in the inflator tube).
Warning provided by tyre pressure moni-
7
toring system (it can also be integrated in
the inflator tube).
Tube for inflating tyres
8
12 volt connector
9
Bottle of sealant
10
Spare tyre valve
11
The valve insert remover
has a gap at
1
the lower end for the valve insert. The valve
insert can only be screwed or unscrewed in
this way. This also applies to its replacement
part
.
11
WARNING
When inflating the wheel, the air compres-
sor and the inflator tube may become hot.
Protect hands and skin from hot parts.
Do not place the hot flexible inflator tube
or hot air compressor on flammable mate-
rial.
Allow them to cool before storing the de-
vice.
If it is not possible to inflate the tyre to at
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
CAUTION
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid
overheating! Before switching on the air
compressor again, let it cool for several mi-
nutes.
Check after 10 minutes of driving
›››
Screw in the inflator tube
Fig. 96
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be
sealed sufficiently with the tyre mobility set.
You should obtain professional assistance
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
Set the tyre pressure to the correct value
again.
Carefully resume your journey, without ex-
ceeding 80 km/h (50 mph), until you reach
the nearest specialised workshop and re-
place the tyre.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious in-
jury.
again
8
.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents