Changing Bulbs - Seat Arona 2018 Owner's Manual

No. Consumer/Amps
Pressure transducer, EPW Solenoid
Valve, TOG Sensor, PWM Electric
5 fan, Camshaft Control Valve, Active
Carbon Tank Valve and Oil Pressure
Regulating Valve (TSI)
Ignition coils (MPI and TSI)
6
Glow plug relay, Suction hose re-
sistance (diesel)
7 Vacuum pump (TSI)
Injectors and EKP Relay Coil (MPI),
8
Fuel metering valve (diesel)
9 Servo sensor
Vref Battery: Gateway, BDM and
10
BCM
Engine Injection Module, Main En-
14
gine Relay, ESC
Automatic Gearbox DQ200 and
15
AQ160
17 50 Diag
18 Starter Motor
ESC (Pump)
20
ABS (Pump)
21 ESC/ABS (Valves)
TH4 Electric fan without A/C for
24
moderate climate countries
Fuses and bulbs
No. Consumer/Amps
TH4 fan with A/C or T5I for moder-
ate climate countries
25
10
PTC1
TJ1/TJ4/TJ7/T6P or TH4/T5I Electric
26
fan for warm climate countries
20
TH4 fan with A/C or T5I for moder-
7.5
ate climate countries
27
PTC2
15
28 PTC3
10
7.5

Changing bulbs

7.5
General notes
7.5
Read the additional information carefully
›››
 page 51
30
Changing bulbs requires a certain degree of
7.5
practical skill.
30
If you choose to change the engine compart-
ment lamps yourself, remember that it is a
60
›››
dangerous area in Safety notes for
40
work in the engine compartment on
page 316.
25
Always use identical bulbs with the same
30
designation. The name can be found on the
base of the bulb holder.
Depending on how equipped the vehicle is,
there are different sets of headlights and tail
lights:
20
Halogen headlights.
●
40
Full-LED main headlights*
●
50 Halogen headlights with LED daytime run-
●
ning lights*
Rear bulb light
●
30
LED rear light*
●
40
Full-LED headlight system*
40
Full-LED headlights handle all light functions
(daylight, side light, turn signal, dipped beam
and route light) with light emitting diodes
(LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the vehicle and the bulbs cannot
be replaced. In case of headlight failure, go to
an authorised workshop to have it replaced.
WARNING
Take particular care when working on
●
components in the engine compartment if
the engine is warm, there is a risk of burns.
Bulbs are highly sensitive to pressure. The
●
glass can break when you touch the bulb,
causing injury.
When changing bulbs, please take care
●
not to injure yourself on sharp parts in the
headlight housing.
»
93