Seat Arona 2018 Owner's Manual page 112

again or wait several seconds. The speed is
stored and the warning activated.
Deactivate: press button
●
. The stored speed is deleted.

The warning can be adjusted for speeds be-
tween 30 km/h (18 mph) and 250 km/h
(155 mph).
Display Oil temperature
The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between 80°C and
. If the engine is under a lot of stress
120°C
and the outside temperature is high, the en-
gine oil temperature can increase. This does
not present any problem as long as the warn-
›››
ing lamps or page 318
 
pear on the display.
Warning and information messages
(Vehicle status)
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
Faults displayed on the instrument panel as
red and yellow warning symbols accompa-
nied with messages and
pending on the case, even an audible warn-
ing. The representation of the messages and
110
symbols may vary depending on the version
of the instrument panel.
or button
 Existing faults can also be checked manually.
To do so, open the menu Vehicle status or
Vehicle
Priority 1 warning (red).
up or flashes (in part accompanied by
audible warnings).
ger! Check the fault and eliminate the
cause. If necessary, seek professional
assistance.
Priority 2 warning (yellow).
lights up or flashes (in part accompa-
nied by audible warnings). Operating
faults or the lack of operating fluids can
cause damage to the vehicle or a fault.
do not ap-
Check the faulty function as soon as
possible. If necessary, seek professional
assistance.
Information message.
tion about processes in the vehicle.
Note
Depending on the equipment, some set-
●
tings and instructions can be carried out or
displayed on the infotainment system as
well.
If there are several warnings at the same
●
›››
 page 37, de-
time, the symbols will be displayed one af-
ter the other for a few seconds. The sym-
bols will stay on until you remove the
cause.
Operation
›››
page 107.
The symbol lights
Stop driving! Dan-

The symbol
It provides informa-
If when switching on the ignition warnings
●
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
Fatigue detection (break recom-
mendation)*
On the screen of the instrument pan-
Fig. 120
el: fatigue detection.
The Fatigue detection informs the driver when
their driving behaviour shows signs of fatigue.
Function and operation
Fatigue detection determines the driving be-
haviour of the driver when starting a journey,
making a calculation of tiredness. This is con-
stantly compared with the current driving be-
haviour. If the system detects that the driver is