Seat Arona 2018 Owner's Manual page 134

What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
›››
for engine ignition page
enable engine ignition, press the
the key inside the vehicle.
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
the passenger doors are automatically disa-
bled.
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
of a bush rubbing against it), all proximity
sensors are disabled for a certain period of
time.
Sensors will again be enabled:
After a time.
●
OR: if the vehicle is unlocked with the but-
●
ton on the key.

OR: if the boot is opened.
●
OR: if the vehicle is unlocked manually with
●
the key.
132
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless Ac-
cess unlocking for a locking and unlocking
cycle.
217. In order to
Move the gear lever to position P (if the ve-
●
button on

hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
Close the door.
●
Push the central locking button
●
mote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 139
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver's door lock.
To check that the function has been deacti-
●
vated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Convenience functions
To close all the electric windows using the
convenience function, keep a finger on the
locking sensor surface
Operation
on the re-

within the following 5 seconds.
B
(arrow) of the door
B
handle for a few seconds until the windows
have closed.
The doors opened by touching the sensor
surface of the door handle depend on the
settings that have been activated in the Easy
Connect system with the /

the SETTINGS > Opening and closing
function buttons.
CAUTION
The sensor surfaces on the door handles
could engage if hit with a water jet or high
pressure steam if there is a valid vehicle
key in the proximity. If at least one of the
electric windows is open and the sensor
surface (arrow) on the handle is activa-
B
ted continuously, all windows will close.
Note
If the vehicle battery has little or no
●
charge, or the vehicle key battery is almost
or entirely out of charge, you will probably
not be able to lock or unlock the vehicle
with the Keyless Access system. The vehi-
cle can be unlocked or locked manually.
To control the proper locking of the vehi-
●
cle, the release function is disabled for ap-
prox. 2 seconds.
If the message Keyless access system
●
is displayed on the screen of the
faulty
dash panel, abnormalities may occur in the
operation of the Keyless Access system.
Contact a specialised workshop. SEAT
button and
