Seat Arona 2018 Owner's Manual page 99

holder. The securing tabs must click into
place.
CAUTION
Take care when removing the rear light unit
to make sure there is no damage to the
paintwork or any of its components.
Note
Make sure you have a soft cloth ready to
●
place under the glass on the rear light unit,
to avoid any scratches.
For LED lights, you can only change the
●
turn signal and reverse light bulbs.
Rear lights (in the rear lid)
Rear lid open: remove the lid.
Fig. 109
Fuses and bulbs
Remove the bulb holder.
Fig. 110
Follow the steps indicated:
1. Check which of the bulbs is defective.
2. Open the rear lid.
3. Remove the rear lid cover in the direction
›››
indicated Fig. 109.
4. Remove the bulb connector
›››
Fig. 110 .
1
5. Remove the bulb holder unlocking the
retaining tabs .
A
4. Change the damaged bulb.
6. Use a cloth to remove any fingerprints
from the glass part of the bulb.
7. Check that the new bulb works properly.
8. Carry out the same actions in reverse or-
der for assembly and pay special atten-
tion to placing the bulb holder, ensuring
that the tabs are properly secured.
Note
For LED lights, you can only change the
●
turn signal and reverse light bulbs.
Number plate light
Note
Number plate lights use LED technology.
LEDs have an estimated life that exceeds
than that of the car. If a light with LEDs fails,
go to an authorised workshop for replace-
ment.
Side turn signals
Turn signal integrated in the rear view
Fig. 111
mirror
The side turn signals are LEDS and are inte-
grated in the rear view mirrors.
»
97