Getparam; Setparam; Flush - Teltonika FM1100 User Manual

6.1.11 getparam ####

Read parameter value. ID consists of 4 digits – first digit identifies profile,
second, third and fourth identifies parameter ID as described in Parameter List
chapter.
Response
details
ID
Value
Example: 'getparam 1245' command will request server IP address in
profile1.

6.1.12 setparam #### #

Sets new value for parameter. ID consists of 4 digits – first digit identifies
profile, second, third and fourth identifies parameter ID as described in Parameter
List chapter. In value field a new parameter value is entered.
Example: 'setparam 1245 127.0.0.1' will change configured IP address in
profile1 with new value

6.1.13 flush #,#,#,#,#,#,#

Initiates all data sending by GPRS to specified target server. Comma
separated parameters go as numbered:
1.# - IMEI
2.# - APN
3.# - GPRS LOGIN
4.# - GPRS PASSWORD
5.# - IP
6.# - PORT
7.# - MODE (0-TCP/1-UDP)
Parameters are separated by comma (no spaces needed). In case you
don't need to enter parameter (Login/Pass) – do not put space, simply put
comma and write next parameter.
Example: opa opa flush 353976012555151,banga,,,212.47.99.62,12050,0
Response details
FLUSH SMS Accepted
# records found on FLASH
Minimum Records to Send: #
GPRS Enabled: #
Time Sync: #
Profile number and parameter ID
Parameter value
FLUSH SMS Accepted
Number of records found on FLASH
Number of minimum saved records
to send
State of the GPRS connection, 0 –
disabled; 1 – enabled
Indicates time synchronization on
Description
Description
46