Battery (2V - 9Ah) - Malaguti Centro 125 IE User Manual

5.16 BATTERY (12V ‑ 9Ah)

The battery housing is in the central channel.
2
Fitting battery
(operation performed before delivery)
To fit battery, proceed as follows:
3
• Take a charged battery.
• Apply the adhesive band supplied with the vehicle
as shown in Fig.44, removing the two protective films
4
from the ends of the adhesive area, as shown by the
arrow in the drawing (P‑Fig.44).
• Remove the 30A general protection fuse.
5
• Undo the 3 screws (V‑Fig.45) and remove the centre
partition under the seat (S‑Fig.45).
6 • Remove the battery fixing cover by removing the
two screws (C‑Fig.46).
• Insert the battery and make sure it is correctly
seated.
• Connect the battery wiring:
- positive pole (+) RED/BLUE cables
- negative pole (‑) to the BLACK cables.
• Wrench down the battery terminals.
• Refit the 30A general protection fuse previously
removed.
ENG
• Check that the battery and the wiring harness are
correctly installed; you can now refit the battery
cover.
• Fit the partition.
42
NEVER invert the cable connections.
Do not use the vehicle if the battery has not been
fitted correctly and connected to its cables.
This may cause failures and short circuit of the
electrical system and its components.
If the battery remains flat it will be seriously
damaged.
We advise you to use protective gloves and
goggles while removing the battery from its
compartment, for example to recharge the
battery.