Menu 2 Setup; Menu 2.1 Display Readout; General Info; Menu 2.1.5 Work Rate - Hardi HC5500 Instruction Book

Menu 2.1 Display readout

General info

The following menu explanations assume you have mastered the general keystrokes and you can "find your way" to the
specific menu. If this is not so, please re-read section "Keys".

Menu 2.1.5 Work rate

It is possible to freely choose which function is to be shown on the 3rd
or 4th line of the display. Choose the submenus of menu [2.1 Display
readout].
Choose a submenu e.g. menu [2.1.5 Work rate].
Press to confirm.
Use or to choose which line is to show data. Picture will
change as shown.
Press to confirm.
DISPLAY TEXT
[2.1.1 Program: Actual]
[2.1.2 Flow rate]
[2.1.3 Optional sensor]
[2.1.4 Time]
[2.1.5 Work rate]
[2.1.6 Volume rate]
[2.1.7 Tank contents]
[2.1.8 Speed]
[2.1.9 Volume: Area]
[2.1.10 Active boom size]
μ
ATTENTION! As some readouts need extra sensors, the relevant sensor has to be connected to get a readout.
μ
ATTENTION! If using UCR for mistblowers:
• Readout is only possible on the 4th line.
• Readout changes as listed below.
2.1.1 Program Actual
2.1.5 Work rate
2.1.6 Volume rate
2.1.9 Volume Area
DESCRIPTION
Programmed and actual application rate
Flow rate out to the boom
There are 8 sub-choices
Actual time
Rate shown in hectares per hour
Actual rate in Litres per hectare
Main tank contents
Driving speed
2 readouts on the same line
Active boom size including end nozzle
Programmed and corrected rate
Rate shown in Metres per hour
Actual rate in Litres per UCR
2 readouts in the same line

6 - Menu 2 Setup

2.1.5.2
WORK RATE
Show here
2.1.5.1
WORK RATE
Show above
31