Hored PS3016S User Manual page 9

Note：
When the switch connected workstations, servers, routers or other ethernet devices the
cable length should be within 100 meters;
The Auto-MDI / MDIX ethernet interface is enabled by default. Category 5,the standard
network cable or crossover cable can be used for Ethernet connection.
Do not connect the RJ45 port to the phone line
3.2
SFP Port connection
PS3016S SFP port only support Gigabit fiber module. Recommended use of standard SFP
module products
The process of installing a fiber module on a switch is as follows:
First, grasp the optic fiber module from the side, insert it smoothly along the SFP port slot
until the optic fiber module and switch are in close contact;
Second, confirm the Rx and Tx ports of the fiber module when connecting, insert one end of
the fiber into the Rx and Tx ports correspondingly, ensure that the Tx and Rx ends of the
interface are connected correctly and the other end of the fiber is connected to another
device;
Third, please check the corresponding indicator light status after power on. If the light
blinking that the link is properly connected, if the light is off , the link is failure, please check
the line to confirm that the corresponding equipment is enabled.