Hored PS3016S User Manual page 10

than 10cm;
Please do not look directly into the optical fiber connector with your eyes as this may cause
eye injury
3.3 Check before power on
Check whether the outlet power supply meets the switch specifications;
Check the power, switches, racks and other equipment have been properly grounded;
Check whether the switch and other network devices are connected properly
3.4 Device initialization
The switch automatically initializes when the power switch is turned on.
Indicator will appear the following situation:
After the power is turned on, the power indicator remains on, the other indicator is off at
this time;
After about 1 second, all lights except for the power light turn on for about 35 seconds and
then turn off; when the SYS light goes flashing, the system runs normally
Port LEDs indicates the connection status of each port, indicating that the switch has
started to work normally
3.5
Web Login
Step1、In the normal operation of the device, connect the computer to the switch's RJ45 port by
network cables
Note：
Does not allow excessive bending fiber, the radius of curvature should not be less
Ensure the cleanliness of the fiber surface;