How To Use Service Remote Controller (Dy9-1349-000) - Canon ELURA10 A Service Manual

3. How to Use Service Remote Controller (DY9-1349-000)

(1) Connect the LANC terminal.
(2) To set up the service mode, turn the HOLD SW to the HOLD
position. When the HOLD SW is returned to its home po-
sition, the product is controlled using its own functions.
(3) LCD indications in the service mode:
4) PAGE is indicated while the FOCUS KEY is held down.
5) BANK is indicated.
6) MODE is indicated.
WR when the BATT mark is presented.
7) ADDR is indicated.
8) DT is indicated (hexadecimal).
(4) The following table shows the key functions available in
the service mode.
< Key Functions in Service Mode >
No. Key name (in service mode)
1 HOLD
2 PAGE +
3 BANK +
4 BANK -
5 ADDRESS +
6 ADDRESS -
7 DAT A +
8 DAT A -
9 ST ORE
10 MODE SELECT
11 PAGE DISPLAY
12 EJECT
CAHPTER 3. INFORMATION FOR REPAIR · SERVICE HINTS
1. HOLD SW
10. MODE
4. BANK -
12. EJECT
6. ADDRESS -
8. DATA -
Function
T ransition to service mode by setting to the HOLD HOLD
position
PAGE is incremented by one.
BANK is incremented by one.
BANK is decremented by one.
ADDRESS is incremented by one.
ADDRESS is decremented by one.
DAT A is incremented by one.
DAT A is decremented by one.
Confirmation/writing of DAT A
RD/WR mode selection
PAGE is indicated on LED of remote controller.
EJECT operation is performed.
3-3
ELURA20 MC A, ELURA10 A
2. PAGE +
SELECT
Fig. 3-2
Key name (in normal state)
ST ART /ST OP
EDIT SEARCH +
EDIT SEARCH -
FF
REW
PLAY
ST OP
PAUSE
REC REVIEW
FOCUS
COUNT ER RESET
6
* : * * : * *
4 5 8 7
11. PAGE
DISPLAY
3. BANK +
9. STORE
5. ADDRESS +
7. DATA +