Install Displacement Pump - Graco E-Flo SP D200S Installation And Parts Manual

Repair
b. For driver with smaller platens and all supply
units: See procedure for D60 3 in. Dual Post
Supply Units on page 32.
6. See Disconnect Pump from Platen on page 30 to
disconnect the platen from the displacement pump.
7. Use two people to lift out the displacement pump.
F . 25
IG
D60 3 in. Dual Post Supply Units
1. Follow the Pressure Relief Procedure on page 22.
2. Turn the disconnect switch (M) to OFF.
3. See Disconnect Displacement Pump in your
pump packages manual.
4. See Disconnect Pump from Platen on page 30 to
disconnect the platen from the displacement pump.
5. Open the main air slider valve (AA).
6. Raise the ram assembly to lift the driver away from
the displacement pump.
7. Remove displacement pump and service as
needed.
32

Install Displacement Pump

D200 3 in. and D200s 6.5 in. Supply Units
1. Insert displacement pump on platen. Follow Con-
nect Platen steps on page 31.
2. See Reconnect Displacement Pump in your pump
package manual.
3. Connect driver:
a. Use wrench on nut (105) on top of ram bar to
lower driver onto displacement pump. See F
24 on page 31. Thread nut (105) up and tighten
it under ram bar. Tighten nut (105) below the
crossbar to 25 ft-lb (34 N•m) maximum.
D60 3 in. Dual Post Supply Units
1. Raise ram to install displacement pump to platen.
2. Insert displacement pump on platen. Follow Con-
nect Platen steps on page 31.
3. See Reconnect Displacement Pump in your pump
packages manual.
.
IG
3A6331C