Checking The Rubber Grip - KTM 250 SX 2019 Owner's Manual

11.41

Checking the rubber grip

Main work
–
Check the throttle cable routing.
The throttle cable must be routed along the back of the
handlebar, to the right of the frame, above the fuel tank
bracket, and to the carburetor. The throttle cable must be
fixed on the fuel tank bracket with a rubber band.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
K01235-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or
the throttle tube.
401197-01
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
102245-10
SERVICE WORK ON THE CHASSIS 11
( p. 71)
p. 64)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
must be located at the top.
Loctite ® 243™
79