Table of Contents
Advertisement
11 SERVICE WORK ON THE CHASSIS
11.11
58
K01143-12
Checking the play of the steering head bearing
Warning
Danger of accidents Incorrect steering head bearing play impairs the handling characteristic and dam-
ages components.
–
Correct incorrect steering head bearing play immediately. (Your authorized KTM workshop will be glad
to help.)
Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the
bearing seats in the frame can become damaged over time.
H01167-01
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Position the brake line and clamp. Mount and tighten
bk
screws
.
Finishing work
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Install front fender. (
p. 60)
–
Install the front wheel.
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Install the start number plate. (
–
Mount the handlebar cushion.
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
»
If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
»
If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and change if neces-
sary.
9
25 Nm (18.4 lbf ft)
Loctite
(
p. 96)
p. 58)
p. 52)
p. 60)
p. 52)
(
p. 59)
(
p. 59)
.
®
243™
Advertisement
Table of Contents
