Table of Contents
Advertisement
12 BRAKE SYSTEM
88
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake
pistons.
–
Remove cotter pin
linings.
–
Clean the brake caliper and brake caliper support.
101737-10
–
Check that leaf spring
7
plate
in the brake caliper support are seated correctly.
100397-01
–
Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
101738-01
–
Correct the brake fluid quantity to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover with membrane. Mount and tighten the screws.
Info
K00521-10
Clean up overflowed or spilled brake fluid immediately
with water.
4
5
, pull out pin
, and remove the brake
6
in the brake caliper and sliding
A
.
5 mm (0.2 in)
p. 147)
Advertisement
Table of Contents
