Draining The Coolant - KTM 250 SX 2019 Owner's Manual

15.4

Draining the coolant

Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or the
cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses
or other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
–
Position the motorcycle upright.
–
Place a suitable container under the water pump cover.
(All SX models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump
cover
K01206-10
(All XC models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump
cover
K01212-11
COOLING SYSTEM 15
1 2
. Take off radiator cap
1
with a new seal ring.
M6 10 Nm (7.4 lbf ft)
1 . Take off radiator cap 2
1
with a new seal ring.
M6 10 Nm (7.4 lbf ft)
.
.
107