Electrical System 14; Removing The Battery (All Xc Models); Installing The Battery (All Xc Models) - KTM 250 SX 2019 Owner's Manual

14.1 Removing the battery
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
14.2 Installing the battery
(All XC models)
1 m (3 ft)
9 V
Preparatory work
–
Press and hold the kill switch
the engine stops.
–
Remove the seat. (
Main work
–
Disconnect negative cable
–
Pull back positive terminal cover
tive cable from the battery.
–
Remove screw
–
Pull holding bracket
the top.
F00138-10
(All XC models)
Main work
–
Position the battery in the battery compartment with the termi-
nals facing forward, and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Connect positive cable
Guideline
Screw, battery termi-
nal
–
Connect negative cable
Guideline
Screw, battery termi-
nal
H00386-10

ELECTRICAL SYSTEM 14

while the engine is idling until
p. 64)
1
from the battery.
2
and disconnect the posi-
3
.
4
forward and remove battery toward
p. 141)
2
.
M6 10 Nm (7.4 lbf ft)
3
to the battery.
M5 2.5 Nm
(1.84 lbf ft)
4
to the battery.
M5 2.5 Nm
(1.84 lbf ft)
1
.
101