Table of Contents
Advertisement
Column 2 corresponds to a needle in the standard position.
Column 1 corresponds to a needle which is half a clip leaner.
Column 3 corresponds to a needle which is half a clip richer.
Column 4 specifies the diameter of the first cylindrical part of the needle. The smaller the diameter of the first
cylindrical part of the needle, the richer the carburation. The larger the diameter of the first cylindrical part of the
needle, the leaner the carburation. The first cylindrical part of the needle has the greatest influence in the lowest
load adjustment.
Info
The top right jet needle A3 corresponds to the richest setting of the carburetor, and the bottom left jet
needle F1 corresponds to the leanest. The optimal carburetor tuning is shown under the respective model.
1
0 0 1
3
0 0 3
5
0 0 5
Carburetor – idle
16.4
Clip position
1... 5
The five possible clip positions are shown here.
2
0 0 2
The carburetor tuning depends on the defined ambient and operat-
ing conditions.
0 0 4
4
B00075-10
The idle setting of the carburetor has a big influence on the start-
ing behavior, stable idling, and the response to throttle opening.
This means that an engine with a correctly set idle speed is easier
to start than if the idle speed is set wrongly.
Info
The carburetor and its components are subject to increased
wear caused by engine vibration. Wear can result in mal-
functioning.
402799-10
The factory setting for the carburetor is set for the following val-
ues.
(All SX models)
Height above sea
level
Ambient tempera-
ture
Super unleaded (95 octane) mixed with 2-stroke engine oil
(1:60) (
TUNING THE ENGINE 16
Clip position from above
301 ... 750 m (988 ... 2,461 ft)
16 ... 24 °C (61 ... 75 °F)
p. 148)
402674-01
113
Advertisement
Table of Contents
