Table of Contents
Advertisement
11.37
Checking the chain, rear sprocket, engine sprocket, and chain guide
Main work
–
1
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
left and right.
Guideline
Chain tension
Turn adjusting screws
markings on the left and right chain adjusters are in the
same position relative to reference marks
wheel is now correctly aligned.
–
Tighten nuts
–
Make sure that chain adjusters
adjusting screws
–
1
Tighten nut
Guideline
H00016-10
Nut, rear wheel spin-
dle
Info
The wide adjustment range of the chain adjusters (32
mm) enables different secondary ratios with the same
chain length.
Chain adjusters
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Shift the transmission to idle.
–
Check the chain, rear sprocket and engine sprocket for wear.
»
If the chain, rear sprocket or engine sprocket is worn:
–
Change the drivetrain kit.
400227-01
SERVICE WORK ON THE CHASSIS 11
.
2
.
55 ... 58 mm (2.17 ...
2.28 in)
3
on the left and right so that the
2
.
4
are fitted correctly on
3
.
.
M25x1.5
4
can be turned by 180°.
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.
3
to the
A
. The rear
80 Nm (59 lbf ft)
p. 52)
p. 52)
75
Advertisement
Table of Contents
