KTM 250 SX 2019 Owner's Manual page 95

Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
K01196-10
101740-10
101741-10
M01181-10
–
Stand the vehicle upright.
–
1
Remove screw cap with membrane
–
Manually press the brake caliper to the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir, extracting it by suction if it
does.
Info
Make sure when pushing back the brake piston that you
do not press the brake caliper against the spokes.
–
3
Remove cotter pins , pull out pin
brake linings.
–
Clean the brake caliper and brake caliper support.
–
5
Check that leaf spring
6
plate in the brake caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation
direction of the brake disc.
–
Insert the new brake linings, insert pin
3
pins .
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
BRAKE SYSTEM 12
2
and the O-ring.
4
, and remove the
in the brake caliper and sliding
4
, and mount cotter
7
is mounted on the
93