Factory Settings Of The Idoil Control Unit - Labkotec idOil-D30 Installation And Operating Instructions Manual

Installation and Operating Instructions | idOil-D30
Depending on how many sensors are
connected to the control unit, the display
may show the following message, for
example: "Detecting sensors, 3 sensor(s)
found".
Once all sensors have been identified, the
display shows the message: SYSTEM OK.
The idOil separator alarm system is now
operational at factory settings.
If the control unit does not identify all connected sensors.
Check the sensor connections.
After the check, press the sensor identification button again.
The control unit will look for the sensors for approx. 2 minutes, unless it
has already found three sensors.
The sensor identification can be stopped by pressing the sensor identification button for 5
seconds.
6.2.

Factory settings of the idOil control unit

System settings
Alarm settings
Inspection settings
Language
Date and time
Alarm buzzer
Alarm repeat (24h)
Alarm delay for all sensors
Alarm reset button
Inspection interval counter and
inspection warning
Figure 19. Three sensors found.
Figure 20. All sensors found.
English
not set
on
on
10 s
on
not set
DOC001602-EN-4
19/51